Resolves#7437 for new `nix` commands only by adding a `--stdin` flag.
If paths are also passed on the cli they will be combined with the ones
from standard input.
One of our CI machines installs Nix via the official script and then
sources the nix-profile.sh script to setup the environment. However, it
doesn't have XDG_STATE_HOME set, which causes sourcing the script to
fail.
Whenever a file conflict happens during "nix profile install" an error
is shown that was previously thrown inside builtins.buildEnv.
We catch BuildProfileConflictError here so that we can provide the user
with more useful instructions on what to do next.
Most notably, we give the user concrete commands to use with all
parameters already filled in. This avoids the need for the user to look
up these commands in manual pages.
At the moment an Error is thrown that only holds an error message
regarding `nix-env` and `nix profile`. These tools make use of
builtins.buildEnv, but buildEnv is also used in other places. These
places are unrelated to Nix profiles, so the error shouldn't mention
these tools.
This generic error is now BuildEnvFileConflictError, which holds more
contextual information about the files that were conflicting while
building the environment.
Building without tests is useful for bootstrapping with a smaller footprint
or running the tests in a separate derivation. Otherwise, we do compile and
run them.
This isn't fine grained as to allow picking `check` but not `installcheck`
or vice versa, but it's good enough for now.
I've tried to use Nixpkgs' `checkInputs`, but those inputs weren't discovered
properly by the configure script. We can emulate its behavior very well though.
so far there were no even remotely measurable objectives, only a general
purpose statement.
this change is intended to focus the team's work on what I (and many
others I talked to) perceive to be the main pain point in the
development process.
Co-authored-by: solene.rapenne@tweag.io
Split `common.sh` into the vars and functions definitions vs starting
the daemon (and possibly other initialization logic). This way,
`init.sh` can just `source` the former. Trying to start the daemon
before `nix.conf` is written will fail because `nix daemon` requires
`--experimental-features 'nix-command'`.
`killDaemon` is idempotent, so it's safe to call when no daemon is
running.
`startDaemon` and `killDaemon` use the PID (which is now exported to
subshells) to decide whether there is work to be done, rather than
`NIX_REMOTE`, which might conceivably be set differently even if a
daemon is running.
`startDaemon` and `killDaemon` can save/restore the old `NIX_REMOTE` as
`NIX_REMOTE_OLD`.
`init.sh` kills daemon before deleting everything (including the daemon
socket).
`init.sh` is tested on its own. We used to do that. I deleted it in
4720853129 but I am not sure why. Better
to just restore it; at one point working on this every other test
passed, so seems good to check whether `init.sh` can be run twice.
We don't *need* to run `init.sh` twice, but I want to try to make our
tests as robust as possible so that manual debugging (where tests for
better or worse might be run ways that we didn't expect) is less
fragile.
It would be incorrect to say that the `sourceInfo` has an `outPath`
that isn't the root. `sourceInfo` is about the root, whereas only
the flake may not be about the root. Thanks Eelco for pointing that
out.
Robert Hensing
Bob van der Linden
Yorick